Broan QS136BC Benutzerhandbuch

Seite von 12
Page 5
ALLURE™   QS1 SERIES
RANGE  HOOD  
WARNING: To reduce the risk of electric shock, 
disconnect from power supply before cleaning.
Aluminum mesh filters: Clean frequently using hot water and a 
mild detergent. Filters are dishwasher safe.
Charcoal filters: Clean filter surfaces frequently with a damp cloth 
and a mild detergent.  DO NOT immerse filters in water or put in dish-
washer. The special “Clean Sense” feature indicates when the filter 
is to be replaced. The dotted lines on the indicator strip will change 
to solid wide lines when it is time to change the filter. The “Clean 
Sense” feature works best when facing toward the cooking surface.
To clean hood: Remove filters. Use a damp cloth and a mild deter-
gent to wipe all grease-laden surfaces. Use care when cleaning fan 
blade - it must not become bent or misaligned.  DO NOT ALLOW 
WATER TO ENTER MOTOR. Make sure all surfaces are completely 
dry before re-installing filters and restoring power.
Motor is permanently lubricated. Do not oil or disassemble motor.
OPERATION
CLEANING
Fan: The 3-position rocker switch (on the left) controls the fan. The 
left position is low speed, center position is off, and right position is 
high speed. An indicator light shows that the fan is on.
Light: The 3-position rocker switch (on the right) controls the lights. 
The left position is low light intensity, center position is off, and right 
position is high light intensity.
INSTALL HOOD
KEYHOLE 
(4)
MOUNTING
SCREW
(4)
Hang hood from (4) 
Mounting Screws (from parts bag). 
Slide hood towards wall until mounting screws are engaged 
in narrow end of (4) 
 Keyholes. Tighten mounting screws 
securely.
PAR20,
50W MAX.
HALOGEN
BULB (2)
- or -
R16,
40W MAX.
INCANDESCENT 
BULB (2)
Replace filters and make sure fan blade turns freely. Turn on 
power at service panel, and test for proper operation.
Connect ductwork to hood. Use 
Duct Tape to make joints 
secure and air tight.
DUCT
TAPE
CAUTION 
DO NOT PUSH ON FAN BLADE. Pushing on the   
              blade may cause it to interfere with other hood parts.
Install (2) PAR20, 50 W Maximum 
Halogen Bulbs  or (2) 
R16, 40 W Maximum 
Incandescent Bulbs. Purchase bulbs 
separately.
!
CAUTION: 
Bulbs may be hot! Refer to bulb packaging 
for further information.
If hood is to be installed Non-Ducted:
Purchase a set of (2) non-ducted filters from your local distributor or 
retailer and attach them to the aluminum mesh filters.
NON-DUCTED FILTERS