Dacor PHW30 Benutzerhandbuch

5

Care and Cleaning

Cleaning

to prevent electric shock or damage to the blower, 

• 

thoroughly dry the filters before reinstalling them 

after cleaning.
to prevent electric shock turn off the main power 

• 

switch (see page 3) before cleaning the range 

hood or filters.
clean the hood only in the manner specified.

• 

to avoid dangerous fumes or damage to your 

• 

hood’s surfaces, use only the types of cleaning 

solutions specified in this manual.
to avoid personal injury, turn off the cooktop or 

• 

range and make sure that the appliance and range 

hood are cool before cleaning.
always wipe stainless steel (silver colored) 

• 

surfaces with the grain. to prevent scratching, do 

not use abrasive cleaners or scrubbers on stainless 

steel or glass surfaces.
to avoid damage to the blower, do not reinstall 

• 

damaged or worn filters (see page 6 for 

replacement part number).

proper cleaning is necessary to ensure safe operation 

and maintain hood performance and appearance. the 

frequency of cleaning should be adjusted according to 

the type and amount of cooking. best results will be 

achieved by cleaning soiled components as soon as pos-

sible.

Cleaning Stainless Steel Surfaces

clean stainless steel surfaces with a mild solution of 

detergent or dishwashing soap and warm water. rinse 

and dry with a soft, lint-free cloth.
you may also use Dacor stainless steel cleaner* on the 

stainless steel surfaces. use it according to the direc-

tions on the package.

Cleaning the Glass

Use a mild glass cleaner to remove finger prints on glass 

surfaces. you can also clean glass surfaces with Dacor 

cook top cleaning creme*. use it according to the 

directions on the package.
* see page 6 for ordering information.

Cleaning the Filters

Clean the filters a minimum of every two months; clean 

them sooner if grease begins to build up.
to remove the filters:

turn off the main power switch (see page 3 for loca-

1. 

tion).
pull on the release lever 

2. 

 a 

 near the bottom of 

the filter and lower it out of the hood. The filters 

are located inside the chimney opening 

 b 

 on the 

bottom of the hood. Remove both filters for clean-

ing.

to clean the filters:
Hand wash the filters in hot water with a mild detergent 

solution or place them in an automatic dishwasher. Dry 

the filters completely before reinstalling them.
to reinstall the filters:

Insert the end of the filter opposite the release lever 

1. 

into the slot right next to the light and main switch 

panel. the release lever must be facing out.
pull on the release lever while sliding the bottom 

2. 

end of the filter into the filter opening.
release the lever.

3.