Liebherr CS Benutzerhandbuch

aker

Safety Instructions and Warnings

• The Ice Maker is designed exclusively to make

ice cubes in quantities needed by a household

and may only be operated with water appropri-

ate for this purpose.

• All repairs and work on the Ice Maker may only

be done by customer service personnel or other

appropriately trained personnel.

•

Do not consume or use the first three

batches of ice. This applies both to using the

appliance for the first time and also using it

after it has not been used for a long period of

time.

•

The manufacturer cannot accept liability for

damage caused by equipment or water lines

between the solenoid valve and the water

supply.

• The Ice Maker will only work if the combined

refrigerator-freezer is connected to the electrical

outlet. It will only make ice cubes if the freezer

compartment is operating.

• The Ice Maker can only make ice cubes if the

upper freezer drawer is completely closed and

the ice cube bin is installed correctly

(Figure 17).

To Start the Ice Maker

To turn the Ice Maker on

• Touch the

Ice Maker icon so the Ice Maker

LED comes on (Figure 21).

After you start the Ice Maker for the first time it may

take up to 24 hours before the first ice cubes are

ready.

Note

The first three batches of ice must not be

consumed or used.

The production capacity is 100 - 120 ice cubes in

24 hours at a temperature of 0°F inside the freezer

compartment.
To have the maximum capacity of approx. 150 ice

cubes in 24 hours, activate the Superfrost function.
Be aware that this increases the energy con-

sumption because the compressor will run con-

stantly.
The ice cubes fall out of the Ice Maker into the ice

cube bin

(Figure 17). When the ice reaches a cer-

tain level in the bin, the appliance stops producing

ice automatically.The ice maker will not fill the bin

to the top.

To turn the Ice Maker off

If you do not need any ice cubes, the Ice Maker

can be turned off independently of the freezer com-

partment.
• Touch the Ice Maker icon so the Ice Maker LED

goes out.

Note

The Ice Maker can also be turned on and

off by pressing the “On/Off” button at the Ice

Maker housing for approximately 1 second

(Figure 19).

Figure 19

Bleeding the Ice Maker

IMPORTANT

To ensure a proper function of the Ice Maker

the water pipe system must be purged of any

air.

• Turn the Ice Maker on by touching the Ice Maker

icon

(Figure 21).

• Open the top freezer drawer.
• Press the button on the Ice Maker housing

(Figure 19) for approx. 3 seconds. The LED

above the button starts blinking.

• Press the button again briefly. The LED blinks

faster.

• Close the top freezer drawer immediately.
The water intake of the appliance opens for 25

seconds and bleeds all air from the pipe system.
• After this the Ice Maker tray

(Figure 20) must

be emptied. Refer to chapter “Ice Maker at

vacations”.

• Finally clean the ice cube bin

(Figure 17).