Manitowoc Ice K00340 Merkblatt

 

1.  Set adapter on dispenser.  Position the adapter so that the front flange of the adapter will be up against the front lip of 

the dispenser.  Adapter may have to be moved towards the back of the dispenser. 

2.  Using the slotted holes in the adapter as a template, drill four (4) 9/64” diameter holes at the bottom of the slots.  

NOTE:  Do not drill deeper than 1/4” past the sheet metal.  Use a drill stop! 

3.  Fasten adapter to dispenser using the four (4) #8 screws supplied with the adapter kit. 
4.  Set the ice machine on top of the adapter.  Align holes in ice machine front angle with threaded bosses on the adapter. 
5.  Secure the ice machine to the adapter with two (2) #8-32 screws supplied with the kit. 
6.  Set the bin cover on the adapter, move backwards until the cover hits the stop, and lower the plastic cover insuring 

that the latch locks. 

7.  To remove the bin cover, twist the knob, lift up, and pull forward. 

Manitowoc Ice, Inc. 

2110 South 26

th

 Street, P.O. Box 1720, Manitowoc, WI  54221-1720 USA                                                                                                                                       

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879                                             8014173 
Web Site - www.manitowocice.com                                                                                                                                                    Rev. 03/31/03 

Place a large fillet of food grade RTV inside edge 
along both sides where adapter touches bin 

#8 Screw  
4 Places 

    Bin Cover 

#8-32 Screw 
 2 Places 

Adapter 

Deflector must stay in place