Whirlpool KUIA15PRL*11 Benutzerhandbuch

7.    Using only front-to-back motions, clean the 

top of the plate, the sidewalls, and the front 
edge of the evaporator. The front-to-back 
motion is important to avoid scratches that 
could keep the ice slab from sliding off the 
evaporator plate.

NOTE: More solution may be necessary if 
there is a large amount of scale buildup on 
the evaporator. The scrubbing process may 
take ten minutes or more, depending on the 
amount of scale buildup on the plate. The entire 
plate should feel smooth when the cleaning is 
fi nished.

8.    Pour the remaining solution from the bottle 

into the water reservoir. Using the empty 
bottle,  fi ll the reservoir with clean water 
to within 1/4" of the top of the overfl ow 
port.

Scrub Front-To-Back 

Add Remaining Cleaner

5.   Read and follow all of the handling informa-

tion that was supplied with the ice machine 
cleaner. 

 

IMPORTANT: Use the entire bottle to clean 
the unit. 

6.    Open the bottle and pour a small amount of 

cleaning solution onto the cleaning brush. 
NOTE: If a brush is not available you may 
use a non scratching, blue Scotch-Brite™ 
pad.

Cleaning Solution 
On Pad

9.   Press and hold the Clean keypad. The 

Clean light will blink to show that the Clean 
cycle is in progress. When the light turns 
off (after approximately 70 minutes), the 
cleaning cycle is complete. During the 
cleaning cycle, the system both cleans 
and rinses itself.

10.  After the cleaning cycle is complete, re-

move the drain cap from the water reser-
voir, and see if any cleaning solution is left 
in the water as it drains out. If the water is 
green in color from the cleaning solution, 
it will be necessary to run another clean-
ing cycle to fl ush the system. Be sure to 
replace the drain cap securely to avoid 
leaking.

11.   When the fl ushing process is completed, 

press the ON keypad to resume ice pro-
duction.