GE IM-5SS Benutzerhandbuch
8
PREPARE FOR INSTALLATION
• Remove the screw (A) that holds the electrical
plug cover
in place. You will not need this screw
and cover.
• Remove the light shield insert (B) and discard it.
• Loosen the two mounting screws (C)
• Loosen the two mounting screws (C)
approximately 1/2
″ (13 mm). DO NOT REMOVE
THESE SCREWS.
INSTALL FILL TUBE EXTENSION
Cut the fill tube extension (10) to the length
(refer to the
(refer to the
template in this section) with a
sharp knife or single-edge razor blade and slide
it onto the fill tube against the stop.
it onto the fill tube against the stop.
C
C
1
2
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS C
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
the label on the back of the refrigerator—
or K
C
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION –
Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
Cover
removed
B
C
A
C
10
SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
3
Power
Switch
Switch
Hole for
wire tie
wire tie
Cut the fill tube extension (10) to this length for
.
C
4
3
⁄
8
″
(11.1 cm)