Monessen Hearth VFCS20DNV Benutzerhandbuch

1

O

N

O

F

F

MILLIVOLT CONTROL (FIGURE 11)
The valve regulator controls the burner pressure which should

be checked at the pressure test point.
If outlet pressure is low, check inlet pressure against data plates

or manual.
Turn captured slotted screw counter clockwise 2 or 3 turns and

then place tubing to pressure gauge over test point (Use test

point “OUT” closest to control knob). After taking pressure

reading, be sure and turn captured screw clockwise firmly to

re-seal. Do not over torque. Check for gas leaks.

Test Port “OUT”

 1.  Remove cover on control panel to show opening for

remote receiver. See Figure 12. 

 2.  Follow remote receiver Instructions to make all neces-

sary wiring connections.

 3.  Place remote receiver in the opening of control panel.

Use two screws provided to attach remote receiver to

the control panel. See Figure 12. 

Remote Receiver 

Cover  

The heater gas inlet connection is 3/8" NPT at the valve. The

inlet is located on left side of stove. Remove front control

plate to better access the inlet.
When tightening up the joint to the valve, hold the valve securely

with a wrench to prevent movement.
Test all gas joints from the gas meter to the heater valve for

leaks using a gas analyzer or soap and water solution after completing connection.  DO NOT USE AN OPEN FLAME.
Check the gas pressure with the appliance burning and the control set to HIGH.