Monessen Hearth VFCS30DNV Benutzerhandbuch

9

1. Ignitor  electrode  positioned

wrong.

1  Replace ignitor.

2. Ignitor electrode is broken.

2.  Replace ignitor.

3. Ignitor electrode not connected

to ignitor cable.

3.  Reconnect ignitor cable.

4.  Ignitor  cable  pinched  or  wet.

Keep ignitor cable dry.

4.  Free ignitor cable if pinched by any metal or tubing.

5. Broken ignitor cable.

5.  Replace ignitor cable.

6. Bad piezo ignitor.

6.  Replace piezo ignitor.

1. Appliance burning vapors from

paint, hair spray, glues, etc.

1.  Ventilate room. Stop using odor causing products while heater is running.

2. Gas leak

2.  Locate and correct all leaks.

3.  Initial burn off.

3.  Ventilate room and turn unit on high until odor is gone. Odor should be gone

after 2 to 3 hours of continuous use.

1.  Not enough fresh air is available

for ODS/ pilot to operate.

1.  Open window and/or door for ventilation.

2.  Low line pressure.

2.  Contact local gas company.

3.  ODS/pilot is partially clogged. 3.  Clean ODS/pilot.
4.  Defective Thermopile.

4.  Check pilot flame. Check wire connections. Check thermopile output — should

be 500 milli-volts across TH/TP and TP Terminals with ON/OFF switch off.

5.  Restrictions  in  incoming  air

flow.

5.  Check for obstructions on bottom of unit. Check for improper log place-

ment.

1.  Gas leak.

1.  Locate and correct all leaks.

2.  Control valve defective.

2.  Replace control valve.

1.  Gas supply turned off or appli-

ance shutoff valve closed.

1.  Turn on gas supply or open manual shutoff valve.

2.  Air in gas lines when installed. 2.  Continue holding down control knob. Repeat igniting operation until air is

removed.

3.  ODS/pilot is clogged.

3.  Replace ODS/pilot assembly or get it serviced.

4.  Gas regulator setting is not cor-

rect (LPG).

4.  Replace gas regulator at tank.