Sharp AR-5516N Benutzerhandbuch

The MAC address (Ethernet address) of the machine is 
printed on the sticker on the left side of the machine near the 
LAN connector. 

–

The push switch on the machine next to the LAN connector 
can initialise the network settings of the machine.

Verify the physical connection.
The machine and the computer you are using for the 
configuration need to be in the same network segment.

–

Verify the general configuration.
• Start the machine without an IP address (in the factory 

default settings).

• The IP address you configure needs to be a unique on the 

LAN.

• The IP address you configure on the machine needs to be in 

the same class of the computer's IP address you are using 
for the configuration.
Example: If the computer's IP address is "192.168.0.xx", 
configure an IP address such as "192.168.0.10" that has not 
been assigned on another network device.

For details on configuring the settings of the machine, see the 
Start Guide.

Start 

Guide

You need a shielded LAN cable. A shielded LAN cable is not 
provided with the machine.

–

There may be defective equipment between the client 
computer running the configuration utility and the machine.
• Check if the green LED (10/100 BASE networking) of the 

machine is on (not blinking).

• If a problem is observed, there may be a defective cable or 

device. Change the power cable, network cable or the 
connected device and see if the problem continues.

–

The machine and the client computer running the 
configuration utility must be in the same segment.
Be sure to setup both in the same segment when installing the 
machine in your environment for the first time.

–

The IP address of the machine and the client computer 
running the configuration utility must be in the same segment.
• Verify the computer's network setting via Network 

properties, or using "ipconfig" command.

• Be sure to assign an IP address for the machine and the 

computer within a same segment.

–

The machine being installed may have the previous setting 
information.
Initialise the network settings of the machine to the factory 
default, and conduct the configuration.

103, 

Start 

Guide