Gaggenau BS 474 Benutzerhandbuch
5
Before You Begin
Tools and Parts Needed
▯
Philips head screwdriver
▯
1/8" drill bit and drill
▯
Measuring tape
Parts Included
▯
Combi-steam oven
▯
1 Torx screw
Power Requirements
The outlet must be properly grounded in accordance
with all applicable codes.
with all applicable codes.
Planning notes
Door hinge not interchangeable.
Distance from furniture body to door front 1.85”
(47 mm).
(47 mm).
Distance from furniture body to outer edge of door
handle 3.7” (94 mm) after retrofitting the handle
(special accessory).
handle 3.7” (94 mm) after retrofitting the handle
(special accessory).
Pay attention to the front protrusion, possibly
including the door handle, for opening drawers at the
sides.
including the door handle, for opening drawers at the
sides.
When planning a corner solution, pay attention to the
door opening angle of at least 90°.
door opening angle of at least 90°.
No other electrical appliance may be integrated into
the cupboard above this appliance.
the cupboard above this appliance.
Do not install the appliance version with the control
panel on the bottom above a dishwasher. Ascending
steam from the dishwasher can damage the appliance
electronics.
panel on the bottom above a dishwasher. Ascending
steam from the dishwasher can damage the appliance
electronics.
You can order the following installation accessories
▯
GZ 010 011: Extension of the supply and drain
hose (length 6.6 ft (2 m))
hose (length 6.6 ft (2 m))
▯
GF 111 100: Descaling and taste filter
Provide the descaling system when connecting the
appliance if the water hardness exceeds 7 dh in order
to reduce the calcification of the appliance.
appliance if the water hardness exceeds 7 dh in order
to reduce the calcification of the appliance.
Preparing kitchen units
Units into which ovens are to be fitted must be heat-
resistant up to 195°F (90°C) and adjacent cabinets
up to 160°F (70°C).
resistant up to 195°F (90°C) and adjacent cabinets
up to 160°F (70°C).
Connection box must be outside of the installation
niche.
niche.
Perform cut-out work on the furniture before inserting
the appliance. Remove any shavings or the function of
the electrical components may be impaired.
the appliance. Remove any shavings or the function of
the electrical components may be impaired.
Secure freestanding units to the wall using a standard
bracket.
bracket.
Only fit the appliance up to a height that allows
accessories to be removed easily.
accessories to be removed easily.
Dimensions and Cabinet
Requirements
Requirements
General Cabinet Requirements
Cabinet requirements vary depending on the model to
be installed. Please consult the section
be installed. Please consult the section
Dimensions
for the details pertaining to your particular model.
All models require:
▯
¼" (6.4 mm) space between the side of the
appliance and an adjacent wall or cabinet door
when intalled at the end of a cabinet run.
appliance and an adjacent wall or cabinet door
when intalled at the end of a cabinet run.
▯
The cabinet base must be flat and capable of
supporting the weight of your appliance when in
use. See the appropriate weight for your model in
the
supporting the weight of your appliance when in
use. See the appropriate weight for your model in
the
Dimensions
section pertaining to your
particular model.