Desa CGESBMR Benutzerhandbuch

www.desatech.com

117190-01B

Figure 7 - Ember Bed Bulb Replacement

(Looking in from Top of Unit)

Figure 8 - Locating Flame Generation

Cylinder

Log Grate

Bulb with
Spring Clip

Screws

Grounding
Connecting Screw

Flame Cylinder Drum

Figure 9 - Flame Generation Cylinder

Drum

Replacing Log Set Ember Bed Bulbs
1. Carefully remove mirror from unit by lift-

ing it gently from the stove. Store in a safe

place or lay it face down on the carpet.

2. From the bottom, lift up the log set ember bed

and remove it from the unit (do not pull up on

logs).

3. Remove spring clip from bulb. Hold socket

and pull out old bulb.

4. Hold socket and push in new bulb. Replace

spring clip.

5. Repeat steps 2 and 3 for the second bulb.

CLEANING AND

MAINTENANCE

Continued

Replacing Flame Generation Bulbs
1. Unscrew the 6 screws from back of stove

shown in Figure 8. Remove metal plate.

AVOID STRESS TO THE WIRES.

2. Locate the ﬂame generation cylindrical drum.

It is constructed of two removable halves; ei-

ther of which can be removed from the unit.

2. Squeeze half of drum cylinder until it's top

edge clears the top drum track. Remove bot-

tom edge of cylinder drum from bottom drum

track. This will give you access to the light

bulbs. Note: Do not exert excessive pressure

on drum cylinder as this may cause damage.

3. Remove spring clip. Hold socket and pull out

old bulb.

4. Hold socket and push in new bulb (DO NOT

exceed wattage). Replace spring clip.

5. Repeat steps 5 and 6 for second bulb.
6. Insert bottom edge of removed cylinder half into

bottom drum track. Gently squeeze drum cylin-

der until it's top edge ﬁts into top drum rack.

7.  Replace the metal plate with  screws.
8.  Replace the log set ember bed.
9.  Replace the mirror. Note: Before replacing, clean

mirror of any dust or ﬁngerprints. Make sure the

mirror side is toward the front of the unit.

10. Replace the top contrasting light housing.

Note:

The contrasting light should be placed

at the mid point of the mirror edge.

11. Replace the metal plate and 4 screws. Replace

the top of the unit by sliding the top forward

until the clips reconnect.

12. Secure the top to the back frame by reattach-

ing screws.