Smeg SA62MFX5 Benutzerhandbuch
Instructions for the installer
26
16. FINAL OPERATIONS
After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids.
Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the
appliance with the one corresponding to the new gas. This label is in the packet together with the
appliance with the one corresponding to the new gas. This label is in the packet together with the
nozzles.
16.1 Regulation of the hob burner minimum level for natural gas
Light the burner and turn it to the minimum position
. Extract the
gas tap knob and turn the adjustment screw at the side of the tap rod
until the correct minimum flame is achieved.
Replace the knob and check burner flame stability: (rapidly turning the
knob from maximum to minimum position, the flame should not go
out). Repeat the operation on all the gas taps.
until the correct minimum flame is achieved.
Replace the knob and check burner flame stability: (rapidly turning the
knob from maximum to minimum position, the flame should not go
out). Repeat the operation on all the gas taps.
16.2 Regulation of the hob burner minimum level for ULPG
In order to adjust the minimum with ULPG, the screw at the side of the tap rod must be turned
clockwise all the way.
The bypass diameters for each individual burner are shown in paragraph “15.2 Burner and nozzle
characteristics table". Once the regulation has been completed, restore the seal on the by-passes
using paint or similar materials.
clockwise all the way.
The bypass diameters for each individual burner are shown in paragraph “15.2 Burner and nozzle
characteristics table". Once the regulation has been completed, restore the seal on the by-passes
using paint or similar materials.
16.3 Mounting the rear top skirtboard
•
Loosen nuts B.
•
Position the skirt above the top, taking care to align pins C
with holes D.
with holes D.
•
Secure the skirt to the top by tightening screws A.
•
ALWAYS INSTALL THE REAR TOP SKIRTBOARD
WHICH IS AN INTEGRAL PART OF THE APPLIANCE
WHICH IS AN INTEGRAL PART OF THE APPLIANCE
16.4 Wall fixing
In order to prevent accidentaltipping of the appliance, for example by a child climbing onto the open
oven door, a stabilizing means must be installed. Please refer to instructions for installation.
oven door, a stabilizing means must be installed. Please refer to instructions for installation.
•
Stretch out the chain attached to the cooker
horizontally so that the other end touches the
wall.
horizontally so that the other end touches the
wall.
•
Mark the wall in the position where the hole is to
be drilled.
be drilled.
•
Drill the hole, insert a wall plug and attach the
chain.
chain.
•
Move the cooker up against the wall.
914773015/ B