Vector VEC157 Benutzerhandbuch

5

4

The VEC157 can be simultaneously charged and operated from a 12 volt DC
source. Make sure the 12 volt DC source can supply minimum 15 amperes of current
if the spotlight is to be operated while the batteries are being charged.  
To check the battery level, press the Battery Status Pushbutton. Charge until Battery
Level Displays green LED lights when the Battery Level Display pushbutton is pressed.
Charge spotlight after each use. 

1. Locate the DC Recharge Port on the bottom of the handle and connect the DC

charger to a 12 volt DC source that can supply at least 15 amps of DC current.

2. Recharge for 3-4 hours maximum or until the green LED lights when the Battery

Level Display pushbutton is pressed. 

3. After recharge, disconnect the Adapter from the external charging/power

source, then disconnect the connector from the DC Recharge Port.

To turn the Spotlight on, squeeze the trigger switch.To turn  the Spotlight off, release
the trigger switch.

To lock the trigger into the ON position, squeeze the trigger switch and move the
trigger locking button (located on the side of the handle) to the locked position. The
spotlight will stay on until the lock is moved to the OFF position and the trigger
released.

1. Make sure all lamps and connected appliances are turned OFF.
2. The 120 Volt AC Recharge Port located on the rear of the spotlight (see back

view) can be recharged using an ordinary household extension cord rated 120
volts (not included). 

3. To recharge, plug an extension cord into the 120 volt AC charger on the back

of the unit and charge until the charge indicator light turns green . 

4. Recharge until the green LED lights, it will take 20-30 hours depending on the

discharge of the battery.

5. Once recharging is completed, disconnect the adapter from the external

charging source.

6. After AC recharging, wait 5 minutes before using spotlight.

VEC157CFL_Manual_013205  5/2/05  6:50 PM  Page 4