Dakota Digital LAT-NR320 Merkblatt

LAT-NR320 

LED Tail Lights for 1970 Chevelle 

 

MAN#650202 

 

1.  Remove the tail light lenses.  There are four screws holding each lens in. 
2.  Remove the tail light bulbs. 

 

3.  We recommended that the lens and housings be cleaned to insure proper mounting and 

visibility of the LED assembly.  If the lenses are in bad shape a new set is suggested.  

4.  DO NOT remove the tape from the led assemblies yet! 

 

 

5.  Test fit the assembly into the lens as shown below to make sure it aligns correctly.     

  

 

6.  Make sure you have BOTH lenses clean and dry so the single use primer applicator can be 

used for both lenses.  Apply the primer to the top and bottom edges of the lens where the tape 
will attach. AFTER THE PRIMER HAS BEEN APPLIED, LET THE LENS DRY FOR 5 
MINUTES BEFORE GOING ON.   

 

 

 

 

MAN#650202