Waterpik Technologies WP-60 Merkblatt

Seite von 2
Prepare the Reservoir:
4
Adjust Pressure and Pause Control:
Replace
 Fill
Insert
2
Select and Insert Tip:
6
Technique Tips for Best Results:
7
REGISTER YOUR
PRODUCT
ONLINE NOW!
PAUSE
Prime Unit (First Time Use Only):
3
High
Low
No
Gap
Always place tip in mouth 
before turning unit on.
Receive up to
$
44
in savings.
www.waterpik.com/register
ON
OFF
PAUSE
5
Using your Waterpik
®
 
 Water Flosser:
1
Model WP-60/65/70
Remove the reservoir 
from base and fill with 
lukewarm water. 
Prior to Very First Use of Unit, Prime Unit: 
Set pressure control slide switch on handle
to
 
high
, point the handle and tip into sink.
Turn unit
 
ON
 until water flows from the handle, 
turn unit 
OFF.
Press tip firmly into 
handle. When tip is 
properly inserted there 
should be no gap between 
control knob and tip. To 
remove tip, simultaneously 
hold control knob down 
and lift tip up.
You can temporarily stop 
water flow by pressing 
the pause button on the 
handle.
For first time 
users, adjust 
pressure control 
to 
lowest position
Gradually increase 
pressure as you 
prefer.
Aim the tip just above the gum line 
at a 90 degree angle.
Starting with the back teeth, follow the  
gumline and pause briefly between teeth.
Continue until all areas around and 
between teeth have been cleaned. 
Lean over sink and close lips 
enough to prevent splashing, 
while still allowing water to flow 
from mouth into the sink.
Turn unit 
ON
Always 
PAUSE
 
or
turn unit 
OFF
 
before 
removing tip from 
mouth. When finished 
empty any excess 
water from reservoir.
20012884-F AA
Water Pik, Inc. 
1.800.525.2774   •   www.waterpik.com
 
1730 East Prospect Road, Fort Collins, CO 80553-0001 USA 
 ©2009 Water Pik, Inc.
Replace the
reservoir onto the base,
PRESSING DOWN FIRMLY
to ensure full seating.
continued
on back
 QUICK START GUIDE
FRONT
radius:  .125”
4.3125”
4”
BACK
radius:  .125”
4.3125”
4”