Sony MZ-R909 Benutzerhandbuch

Seite von 92
21
4
Insert an MD
 (Use a recordable MD for 
recording.)
1
Press OPEN to open the lid.
2
Insert an MD with the label side facing 
front, and press the lid down to close.
z
You can also charge the battery by connecting 
the supplied AC power adaptor directly to the 
recorder.
Connect the supplied AC power adaptor to 
DC IN 3V on the recorder, and then press 
x/CHG while the recorder is stopped.
“Charging” and e appear in the display 
and charging starts. Full charging takes 
about three and a half hours. Charging is 
complete when e disappears. Charging 
time may vary depending on the battery 
condition.
Unplug the AC power adaptor from the AC 
power outlet.
Notes
• The supplied battery charging stand can be 
used only with this recorder. Any other 
models cannot be charged.
• Do not use the recorder to charge any other 
battery besides the supplied one or the one 
designated for it (NH-14WM(A)).
• Though the battery charging stand and the 
battery may become hot during the charging 
procedure, this poses no danger.
• Be sure to use the supplied AC power adaptor.
• When a rechargeable battery is charged for the 
first time or charged after a long period of 
disuse, battery life may be shorter than usual. 
Repeat discharging and recharging a few 
times. The battery life should return to 
normal. The rechargeable battery can be 
recharged approximately 300 times.
• When the battery life of a fully charged 
rechargeable battery becomes about half the 
normal life, replace it.
• Make sure to remove the recorder from the 
battery charging stand and disconnect the AC 
power adaptor from the wall outlet as soon as 
charging is complete. Keeping it connected to 
the power source for a long time may reduce 
the operating efficiency of the battery.
• Please note the following points when 
charging the battery directly with the supplied 
AC power adaptor.
—If you press x/CHG immediately after 
charging has completed, charging will 
begin again. If this happens, press x/CHG 
again to stop the charging operation since 
the battery is already fully charged. 
—Charging stops when you try to operate the 
recorder during charging.
• If you remove the recorder from the battery 
charging stand for more than 3 or 4 seconds 
while it is charging, and then return it to the 
stand, the CHARGE lamp will not go off until 
approximately 6 hours later, no matter how 
many hours the recorder had been on the stand 
till then. Please note, however, that the 
recorder will become full charged when the 
total time on the stand (the time up until you 
removed it and the time after you returned it to 
the stand) reaches approximately 6 hours, 
even if the CHARGE lamp does not go off.