NCR S10 Benutzerhandbuch

Sample Configurations

NCR S10 Desktop Server User Guide

C-3

Install the SCSI CD-ROM drive in the bottom front
drive bay.

Connect power cables and SCSI cables to the 2 GB
SCSI disk drive and the SCSI CD-ROM drive.

Install the memory SIMMs in bank 1 on the system
baseboard (installed in groups of two SIMMs).

Install the PCI Ethernet Adapter in PCI slot 1
(topmost PCI slot).

Install the PCI Token Ring Adapter in PCI slot 2
(below the PCI Ethernet adapter).

Install the ISA Video Board in EISA/ISA slot 2
(second EISA/ISA slot from the top).

To configure the system settings in the BIOS Setup
Utility, follow these steps:

Turn on power to the system. Observe that the
memory test is executed (memory addresses should
be rapidly displayed in upper left-hand corner of
screen). Ignore any memory size mismatch error
displayed on the screen.

Press [Control] + [Alt] + [Esc] when prompted to
enter the BIOS Setup Utility.

Select Load System Defaults and press [Enter].

Select Basic System Configuration. To go from page
to page, press [Page Down] or [Page Up].

Configuring the
System Settings