Motorola T1/E1 Benutzerhandbuch

Canopy  T1/E1 Multiplexer 

 

 

 

 

 

 

September 2004 

 

 

 

 

 

 

     

      T1/E1 Multiplexer FPGA Version 3.4 

 
 

 

Page 45 of 73 

Set timing mode  

NOTE: Timing mode applies to all four E1 lines. Loopback mode loops the T1/E1 
Tx clock to the T1/E1 Rx.  Recovered mode recovers the T1/E1 clock from the 
incoming T1/E1 over Ethernet bit stream (recovers the clock from the far end 
T1/E1). The default timing mode is Recovered. 

 

For master clock timing mode, enter  
set clock source loopback 

RESULT: The system responds 

Clock source is loopback 

 

For slave clock timing mode, enter  
set clock source recovered 

RESULT: The system responds 

Clock source is recovered 

 

Log off 

Enter lo. 
RESULT: The system responds goodbye. 

 

If you are using the EMS to access the system, follow the steps below to log in: 

1.  Select the proper COM Port for your PC.   

NOTE: COM1 through COM4 are supported.    

2. Enter 

the 

User Name.   

NOTE: The default username is admin. This value cannot be changed.   

3. Enter 

the 

Password.   

NOTE: The default password is 123.  If the password has been changed, enter 
the correct password. 

4. Select 

the 

Login button to continue with the login.   

NOTE: If the login is unsuccessful, the system will generate a pop-up error 
window. You may return to the Login window to correct the data. 
 

Issue 3