Moxa Technologies Uport 1200/1400/1600 Merkblatt

 

— 1 — 

— 2 — 

— 3 — 

 

 

UPort is the brand name of MOXA’s USB-to-serial product line, which 
provides a wide range of products and solutions to extend Windows COM 
ports using the PC’s USB port. Important features of UPort products 
include support for hi-speed (480 Mbps) USB 2.0, Moxa CPU, Moxa 
UART, the ability to assign COM port numbers, magnet accessories, and 
mini female DB9 to terminal block. These features make the UPort 
products easy to use and maintain.   

The UPort 1200/1400/1600 line of USB-to-serial hubs includes the 
following models: 

•  UPort 1250 

2-port RS-232/422/485 USB-to-serial hub 

•  UPort 1250I 

2-port RS-232/422/485 USB-to-serial hub w/ 
isolation protection 

•  UPort 1410 

4-port RS-232 USB-to-serial hub 

•  UPort 1450 

4-port RS-232/422/485 USB-to-serial hub 

•  UPort 1450I 

4-port RS-232/422/485 USB-to-serial hub w/ 
isolation protection 

•  UPort 1610-8 

8-port RS-232 USB-to-serial hub 

•  UPort 1650-8 

8-port RS-232/422/485 USB-to-serial hub 

•  UPort 1610-16  16-port RS-232 USB-to-serial hub 
•  UPort 1650-16  16-port RS-232/422/485 USB-to-serial hub 

Before connecting the UPort USB-to-serial hubs to your computer’s USB 
port, we recommend installing the UPort driver first. To do this, follow 
the installation procedure described in Section 3. 

The installation procedure described in Section 3 was done on a PC 
running Windows 2000 (x86). Windows XP and 2003 (32-bit and 64-bit) 
driver installations are the same. UPort can be connected to any upstream 
type A USB port that is on the PC host or on an upstream hub. UPort is 
hot pluggable, and therefore there is no need to power down your 
computer prior to installation. 

After installing the driver, connect the UPort to an upstream host or hub. 
The Found New Hardware wizard will locate the appropriate drivers 
automatically. Once the drivers are found, various windows will pop up 
as UPort’s serial port is being installed. 

When the Found New Hardware wizard finishes installing UPort, use 
the operating system’s Device Manager to check and/or modify the port 
settings. The new COM port will be listed under Ports (COM & LPT). 
 

Before installing the UPort, verify that the package contains the following 
items: 

•  UPort 1200/1400/1600 USB-to-serial hub   
•  1 USB cable 
•  Document and Software CD-ROM 
•  UPort 1200/1400/1600 Quick Installation Guide 
•  Power adaptor (for UPort 1250I/1450I/1600-8) or power cord (for 

UPort 1600-16) 

Notify your sales representative if any of the above items are missing or 
damaged. 
 

1. Run the Setup program located on the UPort 1200/1400/1600 

Document and Software CD-ROM. Click Next to start installing the 
driver. 

 

 

 

 

 

 

 

 

 

2. Click Next to install the driver in the indicated folder. 

 

 

3. Click Install to proceed with the installation.