Sony 8000SF Benutzerhandbuch
495
Still Image Operations
Cha
When using the signal on frame memory source bus 1 or 2 for the input image,
select the signal as described below.
select the signal as described below.
For the method of using a color matte signal, see “Freezing an image and
writing it to memory” (page 496).
writing it to memory” (page 496).
Selecting the signal on a frame memory source bus
As an example, to select a signal on frame memory source bus 1, use the
following procedure.
following procedure.
1
In the auxiliary bus control block, press the AUX delegation button to
which frame memory source bus 1 is allocated, turning it on.
which frame memory source bus 1 is allocated, turning it on.
For allocation of buses to the AUX delegation buttons, see “AUX
Delegation Buttons Settings (Aux Assign Menu)” in Chapter 16 (Volume
2).
Delegation Buttons Settings (Aux Assign Menu)” in Chapter 16 (Volume
2).
2
In the auxiliary bus control block cross-point buttons, select the signal to
be used for the input image.
be used for the input image.
To select a signal with a key or DME effect applied on the frame
memory source bus
In the key control block, press the [FM FEED] button, turning it on.
This automatically assigns the key fill and key source signals being keyed by
the currently selected keyer to frame memory source buses 1 and 2.
When DME is selected on the keyer, the key fill and key source signals to
which a DME effect is applied are assigned.
memory source bus
In the key control block, press the [FM FEED] button, turning it on.
This automatically assigns the key fill and key source signals being keyed by
the currently selected keyer to frame memory source buses 1 and 2.
When DME is selected on the keyer, the key fill and key source signals to
which a DME effect is applied are assigned.
Selecting Outputs and Target Frame Memory
Selecting outputs (FM) and target frame memory
The following description applies to the case of settings for FM1&2, but the
procedures are similar for the other cases.
procedures are similar for the other cases.
1
In the Frame Memory menu, press one of VF1 to VF4, and select the
required HF menu.
required HF menu.
The current status of frame memory appears. (See page 490).
2
From the pair selection buttons, press the buttons corresponding to FM1
and FM2.
and FM2.
This assigns the signals to FM1 and FM2.