3com PS Hub 40 Benutzerhandbuch
DUA1640-5AAA02
Commands
6-9
Viewing the
Configuration
You can use the display command to show current configuration
information for your hub or stack.
information for your hub or stack.
Displaying the Hub Configuration
At the top-level menu, enter:
system display
The CLI displays information similar to this example:
3Com PS Hub 50 (3C16450)
Unit Name: Marketing
Location: Top floor
Contact: James
Time since reset: 2 days, 3 hours, 10 minutes
Operational Version: 1.00
Boot Version: 1.00
Hardware Version: 1.00
Serial Number: 2103332
This information is in the hub’s MIB (Management Information Base)
and is read-only. You can change the Unit name, Location and Contact
using the web interface.
and is read-only. You can change the Unit name, Location and Contact
using the web interface.
If a problem occurs and you need advice from your support
representative, you may be asked for some of the information shown
on this screen.
representative, you may be asked for some of the information shown
on this screen.
Displaying the IP Configuration
At the top-level menu, enter:
ip interface display
The CLI displays the IP address, subnet mask, default router address,
SLIP address and SLIP subnet mask for the hub.
SLIP address and SLIP subnet mask for the hub.