GE 82-POE Benutzerhandbuch

Chapter 2: Installation 

14 

GE-DS-82 and 82-PoE Ethernet Managed Switch User Manual 

 
•  Per 10/100Base-TX, PoE interfaces (Port-1 to Port-8) 

Lit:  indicates the link through that port is successfully 
established 

Blink:  indicates the Switch is actively sending or receiving data 
over that port  

Lit:  indicates the port is providing 48VDC in-line power 

Off:  indicates the connected device is not a PoE Powered 
Device (PD) 

 
•  Per 10/100/1000Base-T port/SFP interfaces 

Lit: indicates the port is operating at 1000Mbps 

Off: indicates the port is operating at 10Mbps or 100Mbps 

Blink: indicates the Switch is actively sending or receiving data 
over that port 

Lit: indicates the port is operating at 100Mbps 

Off: indicates the port is operating at 10Mbps or 1000Mbps 

Blink: indicates the Switch is actively sending or receiving data 
over that port 

 

1. Press the RESET button once. The Switch will reboot automatically. 
2. Press the RESET button for about 10 seconds. The Switch will revert to the factory 
default mode; the entire configuration will be erased. 
3. The 2 Gigabit TP/SFP combo ports are shared with port 9/10 of GE-DS-82 / GE-DS-
82-PoE. Both of them can operate at the same time. 

The rear panel of the Managed Switch includes an AC inlet power socket, which 
accepts input power from 100 to 240VAC, 50-60 Hz. Figure 4 shows the rear panel of 
the Managed Switch.