Rose electronic 2xE Benutzerhandbuch

 
 

 

The basic installation of a single UltraMatrix switch is an easy and 
straightforward procedure. Perform the below steps for all computers 
that will be connected.  It is recommended that all computers be 
powered off.  When a computer is connected and then booted, the 
UltraMatrix will automatically determine the keyboard and mouse types 
used for that computer and no pre-configuration is needed.   
 

 

                             

Figure 3. Single Unit configuration 

The Unit in Figure 3 can be any UltraMatrix 2xE or 4xE model 

 

If removing power from a computer is not practical, pre-configure the 
UltraMatrix to define that CPU port’s keyboard and mouse types.  This 
procedure should only be done if the CPUs keyboard and mouse can 
be disconnected and re-connected without affecting the interface. 
The default keyboard type is PC mode 2, and the default mouse type is 
PS/2.  If the computer being connected, with power applied, uses a 
PC2 keyboard and PS/2 mouse, no pre-configuration is needed. If not, 
pre-configure the keyboard and mouse types for that CPU port before 
connecting the computer (steps 4a-4f).   
 
 
 
 

Please refer to the safety section before installation