Rose electronic 2xE Benutzerhandbuch
ULTRAMATRIX E-SERIES MANUAL
51
Serial menu options
Option 3, 4 and 5 are not available when using a display terminal.
Option 1. Change Starting Computer (From card #1 only)
Select this option to change the starting computer number. To change
the current value press 1; a prompt will display, as shown below. Type
in the new starting computer number and press [Enter].
Option 3, 4 and 5 are not available when using a display terminal.
Option 1. Change Starting Computer (From card #1 only)
Select this option to change the starting computer number. To change
the current value press 1; a prompt will display, as shown below. Type
in the new starting computer number and press [Enter].
The serial option menu will display again. Select Option 7 to save the
new starting computer number to flash memory. Cycle power on the
UltraMatrix switch to distribute the new value to all the other CPU cards
in this switch.
Option 2. Change the serial port baud rate
Select this option to change the baud rate on the serial ports of the
UltraMatrix switch. The serial ports can be set to either 9600 or 57,600
(bps). The option menu shows the current serial port setting. To
change this from current setting press 2. The message below will
appear.
Make sure the terminal or computers communication program’s baud
rate matches the new setting.
You must change or verify that the computer’s baud rate matches the
UltraMatrix baud rate. If you are using Windows HyperTerminal on
your computer, first disconnect from the UltraMatrix switch by clicking
on the HyperTerminal disconnect ICON. Change the baud rate to
match the UltraMatrix switch’s baud rate, then connect to the
UltraMatrix switch by clicking on the call ICON. Press [Enter] and the
serial menu should display in the HyperTerminal window.
Option 3. Receive new main program or kernel from serial port
(This card only)
When new main or kernel programs are available, they can be obtained
from Rose Electronics or downloaded from our web site at
www.rose.com. The diagnostic screen that is displayed when the
UltraMatrix switch is first turned on shows the Kernel and main program
version that is presently installed.
You cannot update the flash memory using only a display terminal; you
must use a standalone computer or Notebook and the new main or
kernel program saved on that computer.
from Rose Electronics or downloaded from our web site at
www.rose.com. The diagnostic screen that is displayed when the
UltraMatrix switch is first turned on shows the Kernel and main program
version that is presently installed.
You cannot update the flash memory using only a display terminal; you
must use a standalone computer or Notebook and the new main or
kernel program saved on that computer.
Enter the starting CPU number
Baud rate changed to 9600 (or 57,600)
Set baud rate of your terminal to 9600 (or 57.600) and press return.
Set baud rate of your terminal to 9600 (or 57.600) and press return.