Cabletron Systems 2H33-37R Benutzerhandbuch

(Read-Only)

Displays the hardware address assigned to each listed port.

State (Read-Only)

There are five states that can display in this field. These states are 
described as follows:

Disabled: Management disabled this interface. No traffic is received or 
forwarded while the interface is disabled.

Listening: The switch is not adding information to the Transparent 
Database. The switch is monitoring the Bridge Protocol Data Unit 
(BPDU) traffic while preparing to move from the learning to the 
forwarding state.

Learning: The switch is learning the addresses on this interface. The 
switch enters the learning state when the Transparent Database is created 
(during start-up or after being deleted), or when the Spanning Tree 
Algorithm detects a network topology change.

Forwarding: The switch is operating and this interface is forwarding 
traffic.

Standby: This interface will not forward any traffic through the switch 
because a loop condition has been detected by the STA.

Status (Toggle)

Allows the user to disable or enable a port by setting the status of the 
listed interface to either ENABLED or DISABLED. To set the port status, 
refer to 

.

or

(Navigation Key)

When the Switch Configuration screen displays, the current port 
configuration information is displayed for the first 8 ports. This field 
allow the user to step to a second screen (if 2H23-50R) to display the 
information for ports 9 through 11. Depending on the current screen 
displayed, the user can navigate back and forth by highlighting the [1-8] 
or [9-11] field and pressing ENTER.