3M 800ab Benutzerhandbuch

19 

7-INSTALLATION (continued)

2010 December

800ab-NA 

7.7  Completion of Taping Heads
See Manual 2 for Complete Instructions:
1.  Place the Upper Taping Head in a convenient 

working position

.2. Use 

Figure 7-6 and tape threading label. 

Position the tape supply roll so the adhesive 

side of tape is facing the front of the taping head 

as it is pulled from the supply roll. 

3.  Attach the threading needle to the end of the 

roll. Guide the threading needle around the wrap 

roller 

(Position 1) then back around the one-

way tension roller 

(Position 2). 

4.  Continue pulling the threading needle down and 

guide it between the two (2) rollers on the apply 

arm 

5.  Pull the threading needle down until the tape 

travels between the apply plate and the ears of 

the apply arm 

(Position 4) until it extends past 

the applying roller.  When properly threaded the 

adhesive side of the tape should be facing the 

knurled rollers at position 2 and also position 3. 

6.  Cut away any excess tape and repeat steps for

  

Lower Taping Head.

 Do not cut against the apply roller -  

 

roller damage could occur.

N/A for this machine.

7.10  Machine Connection to the Mains
For technical specifi cations: 

 Speci f cations
-   Push the LATCHING EMERGENCY STOP 

    BUTTON.
-   The main switch is normally OFF.

Connect the power cord supplied with the machine 

to a wall socket using a plug which complies with the 

safety regulations of your country.

If you intend to use the outboard tape roll holder, 

proceed as follows:

1 - Remove the lower taping head from the machine.

2 - Remove the tape drum bracket assembly, stud 

      spacer, and fasteners from the lower taping head.

3 - Install alternative wrap roller and bracket on the

      head in place of tape bracket.  Replace lower

      head into machine.

4 - Install and secure tape drum bracket assembly

      on the entry end of the lower frame (as shown in

    

7.9  Preliminary Electric Inspection
Before connecting the machine to the mains please 

carry out the following operations:
7.9.1  Make sure that the socket is provided with an 

 

  earth protection circuit and that both the mains 

 

  voltage and the frequency match the specifi -

 

  cations on the name plate.

7.9.2  Check that the connection of the machine 

 

  to the mains meets the safety regulations in 

  

your 

country. 

7.9.3  The machine is fi tted with a main switch 

 

  and a circuit breaker. The user should check 

 

  that the electrical settings of the machine are 

 

  compatible with all the components of the 

  

mains 

system.