NEC NP52G Benutzerhandbuch

3. Projectng an Image (Basc Operaton)

Selectng Default Source

You can set a source as the default source so that the default source will be displayed each time the projector is
turned on.

1.  Press the MenU button.
  The menu will be displayed.
2. Press  the  seleCt

▶ button twice to select [setUP]

and press the seleCt

▼ button or the enter button

to select [general].

3. Press the seleCt

▶ button three times to select [OP-

tiOns(2)].

4. Press the seleCt

▼ button six times to select [de-

faUlt sOUrCe seleCt] and press the enter button.

The [DEFAULT SOURCE SELECT] screen will be dis-

played.

(

→ page

5. select a source as the default source, and press the

enter button.
NOTE: To specify [VIEWER] as the default source on the NP62

or NP52, select [VIEWER] from the [DEFAULT SOURCE SELECT]

screen, and press the ENTER button because detecting the signal

automatically is not available for the Viewer source on the NP62

and NP52.

6. Press the eXit button a few times to close the menu.

7. restart the projector.
The source you selected in step 5 will be displayed.

TIP: When the projector is in Standby mode, applying an RGB signal

from a computer connected to the COMPUTER IN input will power

on the projector and simultaneously project the computer's image.

([AUTO POWER ON(COMP.)]

→ page

NP61/NP41

NP62/NP52