Emerson GXT2-10000RT208 Benutzerhandbuch

The Liebert GXT2-10000RT208 UPS has a standard DB-9 serial port female connector located on the 

rear of the UPS unit. Several signals are provided on this port and are assigned as follows:

Using the following directions to attach the smaller enclosed ferrite 

bead clamp to the communication cable as shown at right:
1. Open the ferrite bead.
2. Place the communication cable inside the ferrite bead groove.
3. Position the ferrite bead as close as possible to the end of the cable 

that connects to the DB-9 connector of the UPS.

4. Close the ferrite bead so that the ferrite bead’s case snaps closed 

with the cable routed through the ferrite bead’s case.

1

Low Battery (open collector)

2

UPS TxD (typical RS-232 levels)

3

UPS RxD (typical RS-232 levels)

4

Remote Shutdown (5-12VDC, 10-24mA max; battery operation)

5

Common

6

Remote Shutdown (short to pin 5); all modes of operation

7

Low Battery (open emitter)

8

Utility Fail (open emitter)

9

Utility Fail (open collector)

* Maximum voltage and current on pins 1, 7, 8 and 9 are 60VDC and 10.0 mA