Lenovo ThinkPad 560Z Notebook PC Model 560Z Benutzerhandbuch
Troubleshooting Charts
Problem
Action
Your PC Card modem
does not work.
does not work.
Make sure that the infrared port is disabled and the modem is set up correctly.
Make sure that the COM port you set for the modem with the ThinkPad
Configuration program is the same in the following procedure and that there is
no resource conflict.
Configuration program is the same in the following procedure and that there is
no resource conflict.
For Windows 98:
To set up the modem, do the following:
1. Click on Start and move the cursor to Settings and Control Panel.
2. Click on Control Panel, and then double-click on Modem.
2. Click on Control Panel, and then double-click on Modem.
The “Modem Properties” window appears.
3. Make sure the PC Card (PCMCIA) modem is in the window.
4. Click on Properties,
4. Click on Properties,
not
Dialing Properties.
5. Click on the Connection tab.
6. If there is a check mark ( ) in the Wait for dial tone before dialing check
6. If there is a check mark ( ) in the Wait for dial tone before dialing check
box, click and remove it.
7. Click on Advanced....
8. If there is a check mark ( ) in the Use error control check box, click and
8. If there is a check mark ( ) in the Use error control check box, click and
remove it.
9. Put a check mark ( ) in the Use flow control check box by clicking on it
and make sure that Hardware (RTS/CTS) is selected.
10. Close the window by clicking on OK.
11. Return to the “Modem Properties” window by clicking on OK.
12. Click on Dialing Properties in the “Modem Properties” window, and fill in all
11. Return to the “Modem Properties” window by clicking on OK.
12. Click on Dialing Properties in the “Modem Properties” window, and fill in all
boxes.
Note: Click on either Tone dialing or Pulse dialing. Most telephones
today use tone dialing.
13. Click on OK.
14. Click on Close to close the window.
15. Close all active windows.
14. Click on Close to close the window.
15. Close all active windows.
Run your modem application again.
PC Card support software
does not recognize your
PC Card.
does not recognize your
PC Card.
Make sure that:
If the PC Card is not a modem, an ATA, a Flash, or an SRAM card, you
have the proper client device driver for the card.
Your PC Card supports PCMCIA Release 2.0, 2.01, or 2.10. Refer to the
manual that came with your PC Card.
If your PC Card does not support PCMCIA Release 2.0, 2.01, or 2.10, you
cannot use PC Card Director. Contact your PC Card supplier.
cannot use PC Card Director. Contact your PC Card supplier.
Your PC Card is working by following the diagnostic instructions for your PC
Card, if any.
Chapter 4. Solving Computer Problems
121
Title: C79FPMST CreationDate: 06/22/98 12:26:52