Zebra Technologies H 2824-Z Benutzerhandbuch
![Zebra Technologies](https://files.manualsbrain.com/attachments/a78f49d565a2596a8b31f4240e25fed2998da2a0/common/fit/150/50/2656e56263d759e2c7910989c000585d7bce0fb5d50f1f63705e38675fa7/brand_logo.gif)
48
LP 2824-Z User Guide
980531-001 A
Troubleshooting
Print Quality Problems
Print Quality Problems
No print on the label.
• You must use the correct media for the method of printing you require. You must use
thermal transfer media.
• Is the media loaded correctly? Follow the instructions in “Loading the Media”in the
Getting Started chapter.
The printed image does not look right.
• The print head is dirty. Clean the print head.
• The print head is under temperature.
• Adjust the print darkness and/or print speed. Refer to the six-flash sequence in “Feed
• The print head is under temperature.
• Adjust the print darkness and/or print speed. Refer to the six-flash sequence in “Feed
Button Modes” later in this chapter, or the
^PR
and
~SD
commands in the ZPL II
Programming Guide.
• The media being used is incompatible with the printer. Be sure to use the recommended
media for your application, and always use Zebra-approved labels and tags.
There are long tracks of missing print (blank vertical lines) on
several labels.
several labels.
• The print head is dirty. Clean the print head.
• The print head elements are damaged. Replace the print head (see “Replacing the Print
• The print head elements are damaged. Replace the print head (see “Replacing the Print
Head” in the Maintenance chapter).
The ribbon sensor settings did not print.
• The printer is set for direct thermal printing; use the
^XA^MTT^XZ
command to reset the
printer for thermal transfer printing and calibrate again.