Zebra Technologies 2824-Z Benutzerhandbuch
Troubleshooting
Print Quality Problems
980531-001 A
LP 2824-Z User Guide
49
The printing does not start at the top of the label, or misprinting of
one to three labels.
one to three labels.
• The media may not be threaded under the media guides. Refer to “Loading the Media” in
the Getting Started chapter.
• The printer needs to be calibrated. Refer to “Auto Calibration” in the Getting Started
chapter.
• The correct media sensor may not be activated. Manual calibration selects the media
sensing method for the labels being used (refer to the
^MN
command in the ZPL II
Programming Guide).
• Verify that the Label Top (
^LT
) command is correctly set for your application (consult the
ZPL II Programming Guide).
A label format was sent to, but not recognized by, the printer.
• Is the printer in pause mode? If so, press the feed button.
• If the status LED is on or flashing, refer to “What the Status Light is Telling You” in this
• If the status LED is on or flashing, refer to “What the Status Light is Telling You” in this
chapter.
• Make sure the data cable is correctly installed.
• A communications problem has occurred. First, make sure that the correct
• A communications problem has occurred. First, make sure that the correct
communications port on the computer is selected. Refer to “Communicating with the
Printer” in the Getting Started chapter.
Printer” in the Getting Started chapter.