FARGO electronic C10 Benutzerhandbuch
RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
38
Resolving problems with the flashing Online LED light
This indicates a reCoverable printing error regarding the print media or supplies. Refer to the
following list for possible causes to this problem.
following list for possible causes to this problem.
Step Procedure
1
Once the problem is corrected, press the on-line button to resume printing. (Or, if
necessary, turn the print power ON and OFF by pressing the On/Cancel button
and send the print job again.)
necessary, turn the print power ON and OFF by pressing the On/Cancel button
and send the print job again.)
2
Check that cards and Ribbon are installed in the Printer. Also, check that cards
are pushed all the way into the Printer and that the Ribbon is installed properly.
are pushed all the way into the Printer and that the Ribbon is installed properly.
3
Check that the proper Ribbon type is installed according to the Ribbon type
option selected in the Printer Driver setup window.
option selected in the Printer Driver setup window.
4
Are you using a Ribbon other than those sold specifically for use with the Card
Printer? Remember, the Printer requires specialized Ribbon rolls in order to
function properly.
Printer? Remember, the Printer requires specialized Ribbon rolls in order to
function properly.
5
Check for a Ribbon or card jam.
6
The Ribbon Sensor may need to be recalibrated.
7
Symptom A: If the Printer has a magnetic encoding module installed and you
are attempting to encode magnetic information onto a card while printing, a
flashing on-line LED can also indicate an encoding mis-verify.
are attempting to encode magnetic information onto a card while printing, a
flashing on-line LED can also indicate an encoding mis-verify.
Symptom B: If information is not encoded properly or encoded onto a bad
magnetic stripe, the Printer is unable to verify the encoded data.
magnetic stripe, the Printer is unable to verify the encoded data.
a. When this happens, the Printer will simply eject the card before printing
begins and the on-line LED will begin flashing.
b. Press the on-line button to resume encoding and printing with a new card.