Primera Technology Automated Optical Disc Printing System Benutzerhandbuch

C. CLEARING A MEDIA JAM

If a disc should become jammed inside the printing area of the

Printer, with the lid closed press the Cartridge Button. This will

eject the Printer Tray. Then open the lid. The Cartridge Carrier

will move to the center position automatically. WAIT FOR THE

CARTRIDGE CARRIER TO STOP MOVING! Then carefully

move the cartridge carrier assembly to the left to gain access to

the printer tray.

D.

TRANSPORTING THE PRINTER

To prevent damage to the Printer’s robotic arm during 

shipment, it is important to properly secure it.
To prepare for transport, remove the ink cartridges and disc

holders, close the front cover and then do the following:
1.  With the front cover closed, switch off power to the unit.
2.  Press and hold the Cartridge Button.
3.  While continuing to hold the Cartridge Button, switch on

power to the unit.

Continue to hold the Cartridge Button for five seconds.  After

several more seconds, the robotics will undock and the arm

will lower.  Power will shut off automatically once the robotics

are in transport position.  If you have the cardboard spacer that

was shipped with the unit, replace the spacer inside the unit

and close the cover.  If you don't have the cardboard spacer,

secure the arm and cartridges to the sides of the unit with tape

and close the cover.

E.

TECHNICAL SUPPORT

If you have difficulties in operating your Printer, the 

procedures in this manual and the SureThing software 

User's Guide should, in most cases, solve the problem. If you

still have difficulty, contact the technical support number 

listed on the insert included in the supply pack that came 

with your Printer.

510921PM.qxd  1/25/2007  8:53 AM  Page 35