Ultra electronic 3503-1002 Benutzerhandbuch
Quick Start Guide
Ultra Electronics Card Systems
Page 2
MAGICARD Sprinter Flip
Setting up your MAGICARD Sprinter Flip
takes just three easy steps:
1.
Unpack and install the printer
A
Preparing a Location for the Printer
B
Removing the Printer from the Box
C
Checking the Package Contents
D
Install the Dye Film
E
Load the Plastic Cards
F
Connect the Printer to a Power Supply
G
Test the Printer Operation
H
Install the Parallel Interface Cable
2.
Load the supplied WINDOWS Driver software.
Ix
Install the WINDOWS Driver (WINDOWS 3.x)
Iy
Install the WINDOWS Driver (WINDOWS 95)
J
Printer Setup
3.
Verify computer-to-printer operation.
K
Verifying Computer to Printer Communication in WINDOWS
L
In case of Difficulty
M
Important Cleaning procedures.
Note: The Ultra WEB site at http://www.ultra.co.uk contains comprehensive technical support information
including the latest downloadable software, WINDOWS Drivers, Technical Bulletins etc
including the latest downloadable software, WINDOWS Drivers, Technical Bulletins etc
Conventions
Throughout this guide, the following conventions are used to identify important
information.
information.
WARNING - Warning messages indicate where personal injury could result from
not following the correct procedures.
not following the correct procedures.
CAUTION - Caution messages indicate where damage to equipment could result
from not following the correct procedures.
from not following the correct procedures.
NOTE - Notes convey important information that is identified within the text.