Citizen Systems iDP3110 Benutzerhandbuch
iDP3110 User's Manual
CITIZEN
12
5.3 Description of Input / Output Signals
(1)
Input signal
All input signals utilize type 74HC of CMOS and can be used in TTL level as the input is pulled up with 3.3 k
Ω
resistance.
- DATA
- DATA
8 bit parallel signal (positive logic)
- STB
Strobe signal for reading out data (negative logic)
- RESET
Signal for resetting the entire unit (negative logic 4ms or more)
(2)
Output signal
TTL is utilized for all output signals. The output is pulled up with 3.3 k
Ω
resistance.
- ACK
Signal for requesting data. ACK is issued at the end of the BUSY signal (negative logic)
-
BUSY
Signal indicating the printer is busy. Input new data when the signal is in “LOW”
condition.(positive logic)
- SELECT Signal indicating the printer is set to a selected condition (on-line). “HIGH” state signifies the
printer is selected.
(3)
Others
- GND
The common circuit ground.
- FG
Equivalent to “case ground”.
•
Input
[ Printer side ]
[ Host side ]
DATA : 74HC373 equivalent
STB : 74HC14 equivalent
RESET : 74HC04 equivalent
STB : 74HC14 equivalent
RESET : 74HC04 equivalent