Crestron electronic CP-WX8240 Benutzerhandbuch

13

4)  Select "Use the following IP address" and configure the IP 

address, Subnet mask and Default gateway for the computer 

accordingly. 

After setting is complete, click [OK] to close the window.

(continued on next page)

[About IP address]
The Network address portion of the IP address setting on your computer must 

be the same as the setting on the projector. Also, the entire IP address on the 

computer must not overlap with that of the other devices on the same network, 

including the projector.

The projector’s settings are as follows.

IP address: 192.168.10.254

Subnet mask: 255.255.255.0

(Network address: 192.168.10 in this case)

Therefore, specify the computer’s IP address as follows.

IP address: 192.168.10.xxx (xxx shows decimal number.)

Subnet mask: 255.255.255.0

(Network address: 192.168.10 in this case)

For example 

Select from 1 to 254 for “xxx” not duplicating with any other equipments. 

In this case, since the IP address of the projector is “192.168.10.254”, specify 

a setting between 1 to 253 for the computer.

• “0.0.0.0” cannot be set to the IP address.

• The projector’s IP address can be changed by using the configuration utility 

via a web browser. (&20)

• If the projector and the computer exist in the same network (i.e., same 

network address), you can leave the default gateway field blank.

• When the projector and the computer exist in different networks, the default 

gateway must be set.