Infocus IN5534 Benutzerhandbuch
44
For IN5534 and IN5532 (Dual Lamp)
1
Turn the projector off and unplug the power cord.
2
Wait 60 minutes to allow the projector to cool thoroughly.
3
Remove the lamp door:
(a) release the top latches by sliding the release buttons toward the rear
of the projector,
(b) slide the top front cover towards the direction of the lens,
(c) remove the 5 screws, then lift the lamp door off.
4
Loosen the 2 captive screws that attach the first lamp housing to the pro-
jector. Carefully remove the lamp housing. Do the same for the second
lamp housing. Dispose of the lamps in an environmentally proper man-
ner in accordance with local disposal laws.
jector. Carefully remove the lamp housing. Do the same for the second
lamp housing. Dispose of the lamps in an environmentally proper man-
ner in accordance with local disposal laws.
5
Install the new lamp housings and tighten the 2 screws.
6
Replace the lamp door by securing the 5 screws.
7
Replace the top front cover by sliding it back into place.
8
Plug in the power cord and press the Power button to turn the projector
back on.
back on.
9
To reset the lamp hour timer, navigate to the Status and Service menu and
select Reset Lamp Hours. See page 33 for details.
select Reset Lamp Hours. See page 33 for details.
NOTE:
The lamp status indicator will show which lamp needs to be
replaced. One blink off every 2 seconds indicates lamp #1 (part number SP-
LAMP-055); two blinks off every 2 seconds indicates lamp #2 (part number
SP-LAMP-056).
Turn off and
unplug projector
unplug projector
Wait 60
minutes
minutes
SP-LAMP-055
SP-LAMP-056
(3a)
(3a)
(3b)
(3c)
(Lamp #1)
(Lamp #2)