Benq MP727 Benutzerhandbuch
Operation
48
English
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
following settings do not affect the projection settings, operation, or performance.
•
Menu display time in the SYSTEM SETUP: Advanced > Menu Settings menu sets
the length of time the OSD will remain active after your last key press. The time length
the length of time the OSD will remain active after your last key press. The time length
ranges from 5 to 30 seconds in 5-second increments. Use
/
to select a suitable time
frame.
•
Menu position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the
OSD position in five locations. Use
/
to select a preferred position.
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for the
OSD menus. Use
/
to select your language.
•
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use
/
to select a screen.
Shutting down the projector
1.
Press
POWER and a confirmation
message displays prompting you.
If you don't respond in a few seconds,
the message will disappear.
the message will disappear.
If you want to cancel the message, press
any key except PAGE /
any key except PAGE /
and
LASER on the remote control.
Do not look into the laser light window or shine
the laser light beam on yourself or others. See
the warning messages on the back of the
remote control prior to using it.
the laser light beam on yourself or others. See
the warning messages on the back of the
remote control prior to using it.
2.
Press
POWER a second time. The
POWER indicator light flashes
orange, the projection lamp shuts down,
and the fans will continue to run for
approximately 90 seconds to cool down
the projector.
orange, the projection lamp shuts down,
and the fans will continue to run for
approximately 90 seconds to cool down
the projector.
3.
Once the cooling process finishes, the POWER indicator light is a steady orange and
fans stop.
fans stop.
4.
Disconnect the power cord from the wall socket if the projector will not be used in an
extended period of time.
extended period of time.
•
To protect the lamp, the projector will not respond to any commands during the cooling
process.
process.
•
for details.
•
If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press POWER again to start
the projector after the fans stop and the POWER indicator light turns orange.
the projector, the fans will run for a few minutes to cool down. Press POWER again to start
the projector after the fans stop and the POWER indicator light turns orange.