Vanguard Managed Solutions 7300 Series Benutzerhandbuch

5-28 

Modifying Your Vanguard 7300

This section explains how to remove and reinstall the T3/E3 ATM Card.

Be sure to review all applicable warnings and cautions in the “General Card 
Replacement Guidelines” section on page 5-2 before you begin.

Use the steps in this table to remove the T3/E3 ATM Card from the Vanguard 7300 
enclosure:

Use the steps in this table to install the T3/E3 ATM Card into the Vanguard 7300 
enclosure:

Using a screwdriver, loosen the captive screws from the front of the 
T3/E3 ATM Card.

To eject the T3/E3 ATM Card, press the two ejector levers outward at the 
same time.

Pull the T3/E3 ATM Card from the enclosure.

Place the module on a clean, grounded, and static-free surface.

Avoid touching areas of integrated circuitry; static discharge can damage 
these circuits.

Open the ejector levers on the T3/E3 ATM Card.

Align the T3/E3 ATM Card with the card rails on the Vanguard 7300 
chassis.

Carefully insert the T3/E3 ATM Card in the card rails and slide the card 
until you feel resistance.

Simultaneously press the ejector levers inward until they lock.

Tighten the captive screws.