Citrix Systems CITRIX NETSCALER 9.3 Benutzerhandbuch
Down Service Reset status : DISABLED
Nagle's Algorithm : DISABLED
Limited Persist Probes : ENABLED
Maximum out-of-order packets to queue: 64
Done
To enable SACK by using the Configuration Utility
1. In the navigation pane, expand System, and click Settings.
2. In the details pane, under Settings, click Change TCP Parameters.
3. In the Configure TCP Parameters dialog box, under TCP, select the Selective
Acknowledgment check box, and then click OK.
A message appears in the status bar, stating that SACK has been configured
successfully.
A message appears in the status bar, stating that SACK has been configured
successfully.
Clearing the Configuration
You have the following three options for clearing your NetScaler configuration.
Basic level. Clearing your configuration at the basic level clears all settings except the
following:
following:
w
NSIP, MIP(s), and SNIP(s)
w
Network settings (Default Gateway, VLAN, RHI, NTP, and DNS settings)
w
HA node definitions
w
Feature and mode settings
w
Default administrator password (nsroot)
Extended level. Clearing your configuration at the extended level clears all settings
except the following:
except the following:
w
NSIP, MIP(s), and SNIP(s)
w
Network settings (Default Gateway, VLAN, RHI, NTP, and DNS settings)
w
HA node definitions
Feature and mode settings revert to their default values.
Full level. Clearing your configuration at the full level returns all settings to their
factory default values. However, the NSIP and default gateway are not changed,
because changing them could cause the NetScaler to lose network connectivity.
factory default values. However, the NSIP and default gateway are not changed,
because changing them could cause the NetScaler to lose network connectivity.
To clear a configuration by using the NetScaler
command line
command line
At the NetScaler command prompt, type the following command:
Citrix NetScaler Administration Guide
133