Citrix Systems CITRIX NETSCALER 9.3 Benutzerhandbuch
Enabling or Disabling the AppFlow Feature
To be able to use the AppFlow feature, you must first enable it.
To enable or disable the AppFlow feature by using the
NetScaler command line
At the NetScaler command prompt, type one of the following commands:
w
enable ns feature appflow
w
disable ns feature appflow
To enable the AppFlow feature by using the configuration
utility
1. In the navigation pane, expand System, and then click Settings.
2. In the details pane, under Modes and Features, click Configure advanced
features.
3. In the Configure Advanced Features dialog box, select the AppFlow check box,
and then click OK.
4. In the Enable/Disable Feature(s)? dialog box, click Yes.
Specifying a Collector
A collector receives flow records generated by the NetScaler appliance. To be able to
send flow records, you must specify at least one collector. You can specify up to four.
However, you cannot export the same data to multiple collectors. You can remove
unused collectors.
send flow records, you must specify at least one collector. You can specify up to four.
However, you cannot export the same data to multiple collectors. You can remove
unused collectors.
To specify a collector by using the NetScaler command line
At the NetScaler command prompt, type the following commands to add a collector
and verify the configuration:
and verify the configuration:
w
add appflowCollector <name> -IPAddress <ipaddress> -port <port_number>
w
show appflowCollector <name>
Example
> add appflowCollector coll1 -IPAddress
> add appflowCollector coll1 -IPAddress
10.102.29.251 -port 8000
Done
> show appflowCollector coll1
1)Collector name: coll1
Collector IPv4 address: 10.102.29.251
Collector UDP port: 8000
Citrix NetScaler Administration Guide
171