Citrix Systems CITRIX NETSCALER 9.3 Benutzerhandbuch

logging

Log the alarm. Possible values: ENABLED, DISABLED. Default value: ENABLED.

To configure an SNMP alarm for throughput or PPS by

using the configuration utility

1. In the navigation pane, expand System, expand SNMP, and then click Alarms.

2. In the details pane, do one of the following:

• Select PF-RL-RATE-THRESHOLD to configure the SNMP alarm for throughput rate.

• Select PF-RL-PPS-THRESHOLD to configure the SNMP alarm for packets per

second.

3. Click Open.

4. In the Configure SNMP Alarm dialog box, specify values for the following

parameters, which correspond to parameters described in “Parameters for
configuring an SNMP alarm for throughput or PPS” as shown:

• Alarm Threshold—thresholdValue

• Normal Threshold—normalValue

• Severity—severity

• Logging—logging

5. Select the Enable check box to enable the alarm.

6. Click OK, and then click Close.

Configuring SNMP Alarm for Dropped Packets

You can configure an alarm for packets dropped as a result of exceeding the throughput
limit and an alarm for packets dropped as a result of exceeding the PPS limit.

To configure an SNMP alarm for packets dropped because

of excessive throughput, by using the NetScaler command

line

At the NetScaler command prompt, type:

set snmp alarm PF-RL-RATE-PKTS-DROPPED [-state (ENABLED | DISABLED)] [-severity
<severity>] [-logging ( ENABLED | DISABLED )]

To configure an SNMP alarm for packets dropped because

of excessive PPS, by using the NetScaler command line

At the NetScaler command prompt, type:

set snmp alarm PF-RL-PPS-PKTS-DROPPED [-state (ENABLED | DISABLED)] [-severity
<severity>] [-logging ( ENABLED | DISABLED )]

Chapter 2

SNMP