Epson Epson Benutzerhandbuch

7.

Make sure the pins in the processor are directly over the

holes in the socket. Then gently push the processor straight

into the socket, pressing evenly on all sides.

If you are installing a 486 processor rather than an Intel
Pentium OverDrive processor, you’ll see an extra row of

holes around the outside of the socket.

8.

Secure the processor by pressing the ZIF handle back to the

closed position.

9.

Change the settings of the jumpers so that they are correct

for the type of processor you installed. (Refer to the “CPU
type jumper settings” table.) You may also need to change
the setting of jumper JP6 to match the processor clock

speed.

If you installed a processor with a different voltage

(check the table under “Processor Upgrades” in

Appendix A), you need to change the settings of jumper

JP1 on the voltage regulator. See the tables under

“Changing the Jumper Settings” for information on all

processor jumper settings.

10. If you are upgrading to a DX DX2, DX4, or Pentium

OverDrive processor, you must also install a heat sink over

the processor. Follow the instructions included with the
heat sink.

11. Replace any option cards you removed; see “Installing an

Option Card” for instructions.

12. Replace the computer’s cover as described under “Replacing

the Cover.” Then see “Post-installation Procedures” for

instructions on configuring your computer with your new

processor.