NDC comm Instant Wave Benutzerhandbuch

•  Internet Multicast Frames 

After selecting a protocol for filtering, click the Apply button to make the changes 
effective immediately, without closing the dialog box, or click OK to accept the 
changes and close the box.   

 

On the Service card, click Perform AP Self Diagnostic Test.  The Hardware 
Diagnosis screen will open (Figure 11)  

 

Click Start and the tests will commence.  As each item is tested a yellow arrow 
will appear alongside it.  If the test is successful, the arrow will change to a green 
tick.  If a failure occurs, an “X” will appear.  You can click Cancel at any time to 
stop the tests.  When the tests have completed, the Cancel button changes to a 
Close button.  Click Close to return to the Service card. 
 

The Access Point’s (AP’s) embedded software is burned into the flash ROM.   
However, an updated AP code may be installed via a COM port using the AP 
COMFig program.  Click on Update AP Firmware (

page 13).  The 

Update AP Firmware dialog box will open.  

Use the Browse button to choose the file to be uploaded to the AP, or type the file 
location and name in the File Name field. 

The Update button will then become enabled.  Click Update to start loading the 
file to the Access Point.  The AP COMFig tool will upload the new executable into 
the AP’s flash memory area.   

When the file transfer is complete, click Close to close the window.  
 

Restores the factory default configurations.  

18  InstantWave High Rate