Fortinet 110C Benutzerhandbuch

• Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

The equipment compliance with FCC radiation exposure limit set forth for 
uncontrolled Environment.

Review the following cautions before installing your FortiGate unit.

• Ensure the FortiGate unit is connected and properly grounded to a lightning 

and surge protector. WAN or LAN connections that enter the premises from 
outside the building should be connected to an Ethernet CAT5 (10/100 Mb/s) 
surge protector.

• Shielded Twisted Pair (STP) Ethernet cables should be used whenever 

possible rather than Unshielded Twisted Pair (UTP).

• Do not connect or disconnect cables during lightning activity to avoid damage 

to the FortiGate unit or personal injury.

Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, 
the operating ambient temperature of the rack environment may be greater than 
room ambient. Therefore, consideration should be given to installing the 
equipment in an environment compatible with the maximum ambient temperature 
(Tma) specified by the manufacturer.

Reduced Air Flow - Installation of the equipment in a rack should be such that 
the amount of air flow required for safe operation of the equipment is not 
compromised.

Mechanical Loading - Mounting of the equipment in the rack should be such that 
a hazardous condition is not achieved due to uneven mechanical loading.

Circuit Overloading - Consideration should be given to the connection of the 
equipment to the supply circuit and the effect that overloading of the circuits might 
have on overcurrent protection and supply wiring. Appropriate consideration of 
equipment nameplate ratings should be used when addressing this concern.

Reliable Earthing - Reliable earthing of rack-mounted equipment should be 
maintained. 

Particular attention should be given to supply connections other than direct 
connections to the branch circuit (e.g. use of power strips).

If required to fit into a rack unit, remove the rubber feet from the bottom of the 
FortiGate unit.

The FortiGate unit can be placed on any flat surface, or mounted in a standard 19-
inch rack unit.