Siemens 3070 Benutzerhandbuch
18
Getting into the ISDN world is easy
Gigaset 3070/3075isdn, GB, A31008-G3070-B100-3-7619
giga3070KAP.fm
09.01.01
Step
by
Step
You can use the
MSN next call
feature by allocating two MSNs to the handsets
11 and 12 and switch to the MSN 22222 for this dialling procedure in the proc-
ess. This is not possible for handsets 13 and 14 as an alternative MSN was not
set up.
ess. This is not possible for handsets 13 and 14 as an alternative MSN was not
set up.
Answering machine (AM) 1 was allocated to business use and AM 2 to person-
al use.
al use.
Ring delay per MSN
Using the ring delay feature you can configure a handset for each individual
MSN to delay response to the call signal. However, during this ring delay time
the handset can accept the call using the "call pickup" function without a call
signal queuing. When this feature is being configured, the time allowed by the
answering machine for recording a message (default: Automatic 2/4) must be
taken into account. When the ring delay that has been set is higher than the
setting on the active AM, there is no call signal as the answering machine ac-
cepts the call beforehand. For information on setting the ring delay, please refer
to "Setting ring delay" on page 28
MSN to delay response to the call signal. However, during this ring delay time
the handset can accept the call using the "call pickup" function without a call
signal queuing. When this feature is being configured, the time allowed by the
answering machine for recording a message (default: Automatic 2/4) must be
taken into account. When the ring delay that has been set is higher than the
setting on the active AM, there is no call signal as the answering machine ac-
cepts the call beforehand. For information on setting the ring delay, please refer
to "Setting ring delay" on page 28
Allocating numbers
When you switch on the device for the first time, the Installation Assistant is
displayed immediately after the handsets have been registered and the service
program has been started. The Assistant makes it very easy to perform the in-
itial configuration. After initial installation you can call up the Installation Assist-
ant again at any time; to skip programming of the feature use the [NO] key and
the next feature will be displayed.
displayed immediately after the handsets have been registered and the service
program has been started. The Assistant makes it very easy to perform the in-
itial configuration. After initial installation you can call up the Installation Assist-
ant again at any time; to skip programming of the feature use the [NO] key and
the next feature will be displayed.