Farallon Communications 612 Benutzerhandbuch
6-2
Netopia ISDN Modem User’s Guide
Placing calls using AT commands
Your communications software can communicate with the Netopia
ISDN Modem using standard AT commands. To configure your
software, select a Hayes-compatible modem configuration, such as
“generic modem,” if no special setting is available for the Netopia
ISDN Modem. Refer to your communications software
documentation for more details.
ISDN Modem using standard AT commands. To configure your
software, select a Hayes-compatible modem configuration, such as
“generic modem,” if no special setting is available for the Netopia
ISDN Modem. Refer to your communications software
documentation for more details.
When you place a call from a PC or Macintosh computer, the
Netopia ISDN Modem recognizes the AT command ATD to dial a
digital ISDN data call. Depending on the setting of S register 60,
56
Netopia ISDN Modem recognizes the AT command ATD to dial a
digital ISDN data call. Depending on the setting of S register 60,
56
Kbps (default) or 64 Kbps B channel transmission speeds are
used. Correct examples of outgoing circuit-switched ISDN modem
commands with dial strings are shown below.
commands with dial strings are shown below.
■
Dialing with spaces: AT D 1 908 555 7891
■
Dialing without spaces: ATD19085557891
■
Making a Toll Saver (Switched 56) call: ATDD 19085551234
Note: All outgoing calls can be forced to be Toll Saver calls by
setting S register 61 to 1.
setting S register 61 to 1.
Enter ATS61=1
Note: Most areas require you to dial ISDN calls with 11 digits
(for example, 1-800-555-1212), even for local calls.
(for example, 1-800-555-1212), even for local calls.
■
Making a Multilink PPP call using two numbers:
ATD19085557891 & 19085555555
ATD19085557891 & 19085555555
You need to use Multilink PPP to make a call using two ISDN
B channels with the Netopia ISDN Modem. See the
B channels with the Netopia ISDN Modem. See the
section later in this chapter for details.