Star Micronics IFBD-HW03/04 Benutzerhandbuch
IFBD-HW03/04 Product Specifications Rev. 0.00
3.4.2. SNMP
Specification
The SNMP of this product has an SNMP engine that operates with UDP/IP. It is possible to control
the product and printer information using the SNMP manager.
•
Supports SNMPv1, and MIB-II (RFC1213), Printer-MIB (RFC1759), HostResource-MIB
(RFC1514), and Star’s PrivateMIB.
•
“public” has reading permission for the community name, and the character string
registered in the “Authentic Community” for the product setting information has writing
permission. However, if there is no character string set for the “Authentic Community,”
the community name “public” has writing permission.
•
Restrictions:
sysContact, sysName, sysLocation are restricted to a maximum of 78 characters (in
single byte characters).
1 is always returned for reading values when ifAdminStatus and ifOperStatus are
read-only.
3.4.2.1. Support MIB
The following describes the MIB that is supported by this product.
Name
Explanation
sysDescr
ASCII character string of device name; version number
sysObjectID
Object ID representing product identification number
sysUpTime
Amount of time system is running from startup (in units of 10msec)
sysContact
ASCII character string of controller name, and contact information
sysName
ASCII character string of domain name for device control
sysLocation
ASCII character string representing physical location of device
sysServices
Value of service of device protocol hierarchy
ifNumber
Number of device network interfaces
ifIndex
Interface identification number
ifDescr
ASCII character string representing information relating to interface
ifType
Physical/link protocol interface type
ifMtu
Maximum possible sending/receiving data gram size
ifSpeed
Interface transmission speed [bit/sec]
ifPhysAddress
Interface physical address
ifAdminStatus
Interface control status
ifOperStatus
Interface operating status
ifLastChange
sysUpTime value when interface operating status changed the last time
ifInOctets
Number of bytes received by interface
ifInUcastPkts
Number of subnetwork unicast packets received and sent by the upper level
ifInNUcastPkts
Number of broadcast and multi-cast packets received and sent by the upper level
ifInDiscards
Number of reception packets discarded regardless of being normal packets
because the buffer is full
because the buffer is full
ifInErrors
Number of reception error packets
ifInUnknownProtos
Illegal protocols or number of reception packets discarded because it is an
unsupported protocol
unsupported protocol
ifOutOctets
Total number of bytes sent
ifOutUcastPkts
Number of send request packets with the unicast from the upper protocol
3-24