Texas Instruments UCC2891 Benutzerhandbuch
www.ti.com
8
EVM Assembly Drawing and Layout
EVM Assembly Drawing and Layout
through
show the top-side and bottom-side component placement for the EVM, as
well as device pin numbers where necessary. A four layer PCB was designed using the top and bottom
layers for signal traces and component placement along with an internal ground plane. The PCB
dimensions are 3.6" x 2.7" with a design goal of fitting all components within the industry standard
half-brick format, as outlined by the box dimensions 2.28" x 2.20" shown in
layers for signal traces and component placement along with an internal ground plane. The PCB
dimensions are 3.6" x 2.7" with a design goal of fitting all components within the industry standard
half-brick format, as outlined by the box dimensions 2.28" x 2.20" shown in
. All components are
standard OTS surface mount components placed on the both sides of the PCB. The copper-etch for each
layer is also shown.
layer is also shown.
Figure 14. Top Side Component Assembly
SLUU178A – November 2003 – Revised December 2006
Using the UCC2891 Active Clamp Current Mode PWM Controller
13