Xerox 5225A Benutzerhandbuch

15 Problem Solving 

380

This section explains the restrictions for TCP/IP.

• The IP address is a unique address administered system-wide. Consult with the 

system administrator when setting the necessary parameters.

• The subnet mask and gateway settings may also be required, depending on the 

networking environment. Consult with the system administrator when setting the 
necessary parameters.

• When a port status is enabled and there is insufficient memory, the port status may 

be disabled automatically. In this case, disable all unused ports and reallocate the 
memory.

• The [Receiving Buffer - LPD] memory allocation needs to be set in response to the 

operating environment. If the memory allocation is too small, it may prevent 
receiving messages.

• The IP address is a unique address administered system-wide. Consult with the 

system administrator when setting the necessary parameters.

• Consult with the Network Information Service (NIS) administrator when setting up 

the network parameters (IP address and other parameters) from a host running NIS.

When the machine is switched off
The following actions take place when the machine is switched off.

• When [Receiving Buffer - LPD] is set to [Spool to Memory]:

All print data spooled in machine memory, including the data currently being printed, 
is deleted. There is no print data on the machine when the machine is switched on.
However, if the machine is switched off immediately after a print request, the print 
data may be stored on the client. In this case, the print request can be reissued when 
the machine is switched on, and the print data is printed on the machine.

• When [Receiving Buffer - LPD] is set to [Spool to Hard Disk]:

All print data spooled on the machine hard disk, including the data currently being 
printed, is retained. A print request can be reissued when the machine is switched 
on, and the print data is printed on the machine.

• When [Receiving Buffer - LPD] is set to [No Spooling]:

All print data in the receiving buffer, including the data currently being printed, is 
deleted. There is no print data on the machine when the machine is switched on.

The LPD port is not active.

Check whether the LPD port 
has been activated.

Activate the port if printing on 
a machine detected using 
Bonjour.